FLAT-MOUNT INSTALLATION:

TO MOUNT USING THE FLAT-MOUNT METHOD,

§          YOU WILL NOT NEED THE TWO WEDGE-NUTS WHEN INSTALLING USING THE FLAT-MOUNT METHOD. 

§          LOCATE A 6MM THREADED HOLE WITH A FLAT SURFACE TO BOLT TO (AN EXAMPLE WOULD BE THE PINCH BOLTS FOR THE CLUTCH OR FRONT BRAKE LEVER). 

§          REMOVE THE EXISTING PINCH BOLT, POSITION TETHER SWITCH OVER HOLE AND THREAD THE APPROPRIATE LENGTH BOLT INCLUDED WITH THIS KIT THROUGH THE TETHER SWITCH AND INTO THE HOLE (DO NOT OVER TIGHTEN 85 IN. LBS. MAX.)

WIRING:

§          locate the two wires connected to the handlebar-mounted, engine run/stop rocker switch. 

§          Follow the wires down below the handlebars and/or bodywork to find a suitable location to splice into one oF them. 

§          Cut one of the wires, (the diagram below shows the + wire, but either one will work) and attach one of the supplied butt connectors to each end of it.

§          Next cut the longer wire loop attached to the bottom of the VORTEX Tether Switch, directly in the middle of the wire.

§          Now connect each of these ends into each of the open ends of the butt connectors. 

§          Install the tether plug into the socket in the main switch and you are finished with the wiring.

IF YOU ARE USING THE TETHER SWITCH AS A MASTER SWITCH, ALWAYS PULL OUT THE PLUG BY THE PLUG ITSELF AND NOT THE CORD.

 THIS WILL PREVENT DAMAGE TO THE WIRE AND PLUG.